How to Diagnose and Solve B2367 Power Sliding Door Override Switch Input Ckt Short to Gnd Issues

Introduction

If you own a car with a power sliding door, you may have encountered the B2367 error code. This code indicates that there is a short circuit in the power sliding door override switch input circuit, which can cause the door to malfunction. In this article, we will guide you through the process of diagnosing and solving this issue.

Step 1: Check the Override Switch

The first step in diagnosing the B2367 error code is to check the override switch. This switch is located on the dashboard and is used to manually open and close the power sliding door. To check the switch, turn off the car and remove the key from the ignition. Then, press the override switch and listen for a clicking sound. If you hear the clicking sound, the switch is working properly. If you do not hear the clicking sound, the switch may be faulty and needs to be replaced.

Step 2: Check the Wiring

If the override switch is working properly, the next step is to check the wiring. Start by inspecting the wiring harness that connects the override switch to the power sliding door control module. Look for any signs of damage, such as frayed wires or loose connections. If you find any damage, repair or replace the wiring as necessary.

Step 3: Check the Power Sliding Door Control Module

If the wiring is in good condition, the next step is to check the power sliding door control module. This module is located under the dashboard on the driver’s side of the car. To access the module, remove the kick panel and the lower dash panel. Then, locate the module and disconnect the wiring harness.

Using a multimeter, check the resistance between the override switch input circuit and ground. If the resistance is less than 10 ohms, there is a short circuit in the circuit. In this case, the power sliding door control module needs to be replaced.

Step 4: Replace the Power Sliding Door Control Module

If the power sliding door control module is faulty, it needs to be replaced. To do this, disconnect the wiring harness and remove the module from the car. Then, install the new module and reconnect the wiring harness.

Step 5: Test the Power Sliding Door

After replacing the power sliding door control module, test the power sliding door to ensure that it is working properly. Use the override switch to open and close the door several times. If the door operates smoothly without any issues, the problem has been solved.

Conclusion

The B2367 error code can be frustrating, but with the right tools and knowledge, it can be easily diagnosed and solved. By following the steps outlined in this article, you can identify the cause of the issue and fix it quickly and efficiently.

FAQs

1. Can I drive my car with the B2367 error code?

It is not recommended to drive your car with the B2367 error code. This code indicates that there is a short circuit in the power sliding door override switch input circuit, which can cause the door to malfunction. It is best to address the issue as soon as possible to avoid any potential safety hazards.

2. How much does it cost to replace the power sliding door control module?

The cost of replacing the power sliding door control module can vary depending on the make and model of your car. On average, the cost can range from $200 to $500 for parts and labor.

3. Can I replace the power sliding door control module myself?

Replacing the power sliding door control module can be a complex task and requires some technical knowledge. If you are not comfortable working with electrical components, it is best to have a professional mechanic perform the replacement.