How to Fix P1380 Ignition Coil – Cylinder 2 – Early Activation Fault

Introduction

If you’re experiencing a P1380 error code on your vehicle, it means that there is an issue with the ignition coil in cylinder 2. This can cause your engine to misfire, run rough, or even stall. Fortunately, fixing this issue is relatively simple and can be done at home with a few basic tools. In this article, we’ll walk you through the steps to fix the P1380 error code and get your vehicle running smoothly again.

Step 1: Diagnose the Problem

Before you can fix the P1380 error code, you need to diagnose the problem. Start by using an OBD-II scanner to read the error code. This will give you a better idea of what’s causing the issue. If the error code is P1380, then you know that the problem is with the ignition coil in cylinder 2.

Step 2: Replace the Ignition Coil

Once you’ve diagnosed the problem, it’s time to replace the faulty ignition coil. Start by locating the ignition coil in cylinder 2. This is typically located near the top of the engine and is connected to the spark plug. Use a socket wrench to remove the bolts that hold the ignition coil in place. Once the bolts are removed, gently pull the ignition coil out of the engine.

Next, install the new ignition coil in the same location. Make sure that it is securely in place and that the bolts are tightened properly. Once the new ignition coil is installed, reconnect the electrical connector.

Step 3: Clear the Error Code

After you’ve replaced the faulty ignition coil, it’s important to clear the error code. This will reset the vehicle’s computer and ensure that the error code doesn’t reappear. To clear the error code, use an OBD-II scanner to reset the vehicle’s computer. Once the computer has been reset, start the engine and make sure that the P1380 error code doesn’t reappear.

Step 4: Test Drive the Vehicle

After you’ve replaced the faulty ignition coil and cleared the error code, it’s important to test drive the vehicle. This will ensure that the issue has been resolved and that the vehicle is running smoothly. Take the vehicle for a short drive and pay attention to how it runs. If everything seems to be running smoothly, then you’ve successfully fixed the P1380 error code.

Conclusion

Fixing the P1380 error code is relatively simple and can be done at home with a few basic tools. By following the steps outlined in this article, you can replace the faulty ignition coil and get your vehicle running smoothly again. Remember to always diagnose the problem before attempting any repairs and to clear the error code after replacing the faulty part.

FAQs

1. Can I drive my vehicle with a P1380 error code?

It’s not recommended to drive your vehicle with a P1380 error code. This can cause your engine to misfire, run rough, or even stall. It’s best to fix the issue as soon as possible to avoid any further damage to your vehicle.

2. How much does it cost to fix a P1380 error code?

The cost to fix a P1380 error code will vary depending on the make and model of your vehicle and the cost of the replacement parts. However, it’s typically a relatively inexpensive repair that can be done at home with a few basic tools.

3. How often should I replace my ignition coils?

The lifespan of ignition coils can vary depending on the make and model of your vehicle and how often you drive it. However, it’s generally recommended to replace your ignition coils every 100,000 miles or so to ensure that your vehicle is running smoothly.