How to Fix P1383 Ignition Coil – Cylinder 5 – Early Activation Fault

Introduction

If you’re experiencing a P1383 error code on your vehicle, it means that there is an issue with the ignition coil in cylinder 5. This can cause your engine to misfire, run rough, and even stall. Fortunately, fixing this issue is relatively simple and can be done at home with a few basic tools. In this article, we’ll walk you through the steps to fix the P1383 error code and get your vehicle running smoothly again.

Step 1: Diagnose the Problem

Before you can fix the P1383 error code, you need to diagnose the problem. Start by using an OBD-II scanner to read the error code. This will give you a better idea of what’s causing the issue. If the error code is P1383, then you know that the problem is with the ignition coil in cylinder 5.

Step 2: Replace the Ignition Coil

Once you’ve diagnosed the problem, it’s time to replace the faulty ignition coil. Start by locating the ignition coil in cylinder 5. This will typically be located near the top of the engine and will have a wire running to it. Use a socket wrench to remove the bolts holding the ignition coil in place. Once the bolts are removed, gently pull the ignition coil out of the engine.

Next, install the new ignition coil in the same location. Make sure that the wire is securely connected to the ignition coil and that the bolts are tightened down snugly. Once the new ignition coil is installed, clear the error code using your OBD-II scanner.

Step 3: Test the Vehicle

After replacing the ignition coil and clearing the error code, it’s important to test the vehicle to make sure that the issue has been resolved. Start the engine and let it run for a few minutes. Listen for any unusual sounds or vibrations. If the engine is running smoothly, then the issue has been resolved.

Conclusion

Fixing the P1383 error code is a relatively simple process that can be done at home with a few basic tools. By following the steps outlined in this article, you can replace the faulty ignition coil and get your vehicle running smoothly again.

FAQs

1. Can I drive my vehicle with a P1383 error code?

It’s not recommended to drive your vehicle with a P1383 error code. This can cause your engine to misfire, run rough, and even stall. It’s best to fix the issue as soon as possible to avoid any further damage to your vehicle.

2. How much does it cost to fix a P1383 error code?

The cost to fix a P1383 error code will vary depending on the make and model of your vehicle and the cost of the replacement ignition coil. However, this is a relatively simple repair that can be done at home with a few basic tools.

3. How often should I replace my ignition coils?

The lifespan of ignition coils can vary depending on the make and model of your vehicle and how often you drive it. However, it’s generally recommended to replace your ignition coils every 100,000 miles or so to ensure that your engine is running smoothly.